Replacing an electric water heater can be a daunting task, especially if you’re not experienced in plumbing. The process can be time-consuming and requires a few basic tools. However, if you’re willing to put in the effort, you can save yourself a significant amount of money by doing it yourself. In this article, we’ll provide you with step-by-step instructions on how to replace an electric water heater. We’ll also include some tips and tricks to make the process easier.
Before you begin, it’s important to gather the necessary tools and materials. You’ll need a new water heater, a water heater drain pan, a new pressure relief valve, Teflon tape, a pipe wrench, a pair of pliers, a screwdriver, and a level. Once you have all of the necessary supplies, you can begin the replacement process. Begin by turning off the water supply to the water heater. Next, disconnect the electrical power to the water heater. Once the water and power have been disconnected, you can remove the old water heater from its place. Be careful not to damage the floor or walls when removing the old water heater.
Next, you’ll need to install the new water heater. First, place the new water heater in place. Make sure that the water heater is level. Next, connect the water supply to the water heater. Finally, connect the electrical power to the water heater. Once the new water heater is installed, you’ll need to turn on the water supply and the electrical power. Check for leaks around the water heater connections. If there are any leaks, tighten the connections until the leaks stop. Finally, you’ll need to set the temperature on the new water heater. Once you’ve set the temperature, you’re finished replacing your electric water heater.
How To Replace An Electric Water Heater
Replacing an electric water heater is a job that can be completed in a few hours with the right tools and materials. By following these steps, you can safely and easily replace your old water heater with a new one.
1.
Turn off the power to the water heater at the circuit breaker. This will prevent you from being electrocuted while you are working on the water heater.
2.
Turn off the water supply to the water heater. This will prevent water from leaking out of the water heater while you are working on it.
3.
Drain the water from the water heater. To do this, connect a hose to the drain valve at the bottom of the water heater and open the valve. Allow the water to drain into a bucket or drain.
4.
Disconnect the water lines from the water heater. To do this, use a wrench to loosen the nuts that hold the water lines in place. Be careful not to damage the water lines.
5.
Disconnect the electrical wires from the water heater. To do this, use a screwdriver to loosen the screws that hold the electrical wires in place. Be careful not to touch the electrical wires with your bare hands.
6.
Remove the old water heater from the wall. To do this, use a pry bar to gently pry the water heater away from the wall. Be careful not to damage the wall.
7.
Install the new water heater on the wall. To do this, lift the new water heater into place and secure it to the wall with screws. Be sure to use a level to make sure that the water heater is level.
8.
Connect the water lines to the new water heater. To do this, use a wrench to tighten the nuts that hold the water lines in place. Be careful not to overtighten the nuts.
9.
Connect the electrical wires to the new water heater. To do this, use a screwdriver to tighten the screws that hold the electrical wires in place. Be careful not to overtighten the screws.
10.
Turn on the water supply to the water heater. To do this, turn the valve on the water supply line all the way open.
11.
Turn on the power to the water heater at the circuit breaker. To do this, turn the circuit breaker all the way on.
Your new water heater is now installed and ready to use.
