10 Easy Steps on How to Replace Pull Cord on Lawn Mower

Replacing the pull cord on a lawn mower may seem daunting, but it is a relatively simple repair that can be completed in less than an hour. This guide will provide step-by-step instructions on how to safely and efficiently replace your lawn mower’s pull cord for both electric and recoil mowers. Before you begin, it is crucial to gather the necessary tools and safety gear, including safety glasses, gloves, a wrench or socket set, and a new pull cord. Additionally, ensure that your lawn mower is disconnected from the power source and the spark plug is removed.

Firstly, identify the location of the pull cord assembly, typically found on the side or top of the lawn mower. Remove the bolts or screws that secure the assembly and carefully disconnect the old pull cord from the starter mechanism. Next, measure the length of the old cord and cut a new pull cord to the same length, leaving some extra length for tying. Feed the new cord through the hole in the starter mechanism and tie a secure knot at the end. Ensure the knot is snug but not too tight to prevent it from slipping.

Finally, reassemble the pull cord assembly by aligning the starter mechanism with the hole in the mower housing. Secure the assembly using the bolts or screws and gently pull the cord to check its tension. Adjust the tension by winding or unwinding the cord as needed. Once the tension is correct, reattach the spark plug and reconnect the power source. Now, your lawn mower is ready to operate with a new pull cord.

How To Replace Pull Cord On Lawn Mower

Replacing the pull cord on a lawn mower is a relatively simple task that can be completed in a few minutes. By following these steps, you can quickly and easily get your lawn mower up and running again.

1. Disconnect the spark plug wire. This is a safety precaution to prevent the mower from starting while you are working on it.

2. Remove the pull cord cover. This is usually held in place by a few screws. Once the cover is removed, you will have access to the pull cord assembly.

3. Disconnect the old pull cord. There is usually a knot or tie that holds the pull cord in place. Once the knot is undone, you can simply pull the old pull cord out of the assembly.

4. Install the new pull cord. Feed the new pull cord through the assembly and tie a knot or tie to secure it. Make sure that the knot is tight so that the pull cord does not come loose.

5. Reattach the pull cord cover. Once the new pull cord is installed, you can reattach the pull cord cover. Make sure that the screws are tightened securely.

6. Reconnect the spark plug wire. Once the pull cord cover is reattached, you can reconnect the spark plug wire.

   Your lawn mower is now ready to use again.

   People Also Ask About How To Replace Pull Cord On Lawn Mower

   How do I remove the recoil starter from my lawn mower?

   To remove the recoil starter from your lawn mower, you will need to:

   1. Disconnect the spark plug wire.

   2. Remove the starter cover.

   3. Remove the bolts that hold the recoil starter in place.

   4. Pull the recoil starter straight out of the engine.

      How do I replace the pull starter rope on a lawn mower?

      To replace the pull starter rope on a lawn mower, you will need to:

      1. Follow the steps above to remove the recoil starter.

      2. Unwind the old pull starter rope from the recoil starter.

      3. Wind the new pull starter rope onto the recoil starter.

      4. Reattach the recoil starter to the engine.

         How do I adjust the pull cord tension on a lawn mower?

         To adjust the pull cord tension on a lawn mower, you will need to:

         1. Locate the tension adjustment screw on the recoil starter.

         2. Turn the screw clockwise to increase the tension or counterclockwise to decrease the tension.