Your Toyota RAV4 is a reliable and capable vehicle, but like all cars, it requires routine maintenance to keep it running at its best. One of the most important maintenance tasks is changing the oil and filter, and your RAV4 will let you know when it’s time for a change by turning on the maintenance light. However, once you’ve changed the oil and filter, you’ll need to reset the maintenance light so that it doesn’t continue to remind you to perform that task. Resetting the maintenance light is a simple process that can be completed in a few minutes. Here are the steps on how to reset maintenance light on Toyota RAV4:
First, locate the odometer button on the dashboard. It is usually located on the left side of the steering wheel, near the speedometer. Once you’ve found the odometer button, press and hold it for about five seconds. The maintenance light will begin to flash. Continue to hold the odometer button until the maintenance light turns off. This may take about 10 seconds. Once the maintenance light has turned off, release the odometer button. The maintenance light has now been reset and will not turn on again until it is time for the next oil change.
Resetting the maintenance light on your Toyota RAV4 is a simple and important task that can help you keep your vehicle running at its best. By following the steps outlined above, you can easily reset the maintenance light and ensure that you’re aware of when it’s time for an oil change. In addition, resetting the maintenance light can help you avoid any potential problems that may arise if the oil is not changed on time.
Confirming the Maintenance Reset
To confirm the maintenance reset, turn the ignition key to the “ON” position without starting the engine. The maintenance light should illuminate briefly and then turn off. If the light remains on, the reset was not successful. Repeat the steps carefully and ensure you hold the trip button for the full 10 seconds during step 3.
Additionally, you can verify the maintenance reset status by checking the odometer. After the reset, the odometer should display “000000” or a similar indication of a cleared maintenance interval.
The table below summarizes the steps involved in confirming the maintenance reset:
| Step | Action |
|---|---|
| 1 | Turn the ignition key to the “ON” position. |
| 2 | Check if the maintenance light turns on briefly and then off. |
| 3 | If the light remains on, repeat the reset procedure. |
| 4 | Check the odometer for a “000000” or similar indication of a cleared maintenance interval. |
How To Reset Maintenance Light On Toyota Rav4
The maintenance light on your Toyota RAV4 is a reminder that your vehicle is due for service. It is important to reset this light after you have completed the necessary maintenance. Here are the steps on how to reset the maintenance light on a Toyota RAV4:
- Turn the ignition to the “on” position, but do not start the engine.
- Press and hold the “ODO/TRIP” button on the dashboard.
- While holding the “ODO/TRIP” button, turn the ignition to the “off” position.
- Continue to hold the “ODO/TRIP” button for about 10 seconds.
- The maintenance light will begin to flash. Release the “ODO/TRIP” button.
- Press the “ODO/TRIP” button one more time to reset the maintenance light.
People Also Ask About How To Reset Maintenance Light On Toyota Rav4
How do I reset the maintenance light on my Toyota RAV4 2019?
To reset the maintenance light on a 2019 Toyota RAV4, follow the steps outlined above.
How do I reset the maintenance light on my Toyota RAV4 2018?
To reset the maintenance light on a 2018 Toyota RAV4, follow the steps outlined above.
How do I reset the maintenance light on my Toyota RAV4 2017?
To reset the maintenance light on a 2017 Toyota RAV4, follow the steps outlined above.
